Jeep AX5 5 Spd AX4 4 Spd Transmission Bearing Rebuild Kit 1984-1987 (Without Synchros) This is a transmission rebuild kit for the Jeep AX4 and AX5 1984-1987 Transmission This is a rebuild kit for a 1984-87 Jeep AX5 5 Speed and AX4 4 Speed Manual Transmissions that use a nut on the end of the counter gear instead of a snap ring. The input bearing number used in this kit is either 32TM03 or 32BCS4-2. The input bearing is 23mm wide (thick). Special note: This transmission was produced with four different input bearings. To make sure you are getting the correct kit, please check your input bearing. If you have a 20mm wide input bearing, please see my other listing! This kit comes with all the main roller bearings, input pocket needle, seals and gaskets. The AX5 has a cast iron center plate and is used behind the 4 cylinder engine