This TransGo SHIFT KIT® Valve Body Repair Kit fits 2015-2019 Ford vehicles equipped with the GEN2 6R80 and 2017-on 6R100.

If you are working on a GEN1 2006-2014, use TransGo part SK 6R80-A.

Common concerns with this transmission are TCC shudder, rough coast down shifts, gear ratio error and solenoid performance codes. Firstly, these complaints are the result of the wear in the pressure regulator (PR) valve bore and the pressure regulator valve balance bushing. Secondly, the torque converter clutch regulator valve design and calibration were in dire need of an upgrade to address the TCC shudder complaint.

Features and benefits:

The kit includes a hardened steel drop-in two-piece pressure regulator valve and a redesigned TCC regulator valves for a quick no-hassle install. Our drop in valves require no reaming or tooling.

Both the redesigned drop-in steel two-piece PR valve and TCC regulator valve feature longer lands which restores the hydraulic integrity of the circuit by utilizing previously unused and therefore unworn areas of their bore. Furthermore, the longer lands increase bore longevity by redistributing the load over a greater surface area. The kit also includes new rubber damper inserts that flatten out over time and new wire retainer clips to replace the occasional broken one.

Corrects/Prevents/Reduces:

28-46 MPH TCC shudder due to TCC regulator malfunction

Erratic pressure due to PR malfunction

Soft or long shifts

Coast downshift clunk

Gear ratio codes: P0731, P0732, P0733, P0734, P0729

Shift error codes: P0781, P0782, P0783, P0784, P0829

Includes:

Patented drop-in USA-made hardened steel two-piece PR valve

USA-made aluminum PR valve boost bushing

Drop-in USA-made hardened steel TCC regulator valve

(2) Calibration springs

(4) New valve body bore plug wire retainers

(6) New solenoid damper rubber inserts

Tech Tips:

Avoid overheating and increase cooler flow with TransGo 6R80-CLR-BYPASS cooler bypass valve. 

High mileage vehicles? If you have a valve body with a lot of miles on it, you may get a persistent coast-down clunk or slip-sliding shifts when hot.  Those valve bodies will need to have the solenoid regulator and lube regulator bores reamed in order to fully restore the hydraulic integrity of the circuits. TransGo offers two kits to do it, one with tools and one without. The kit with tools includes two guides and a reamer that can be used on both bores, if you already have the tools, you can buy just the valves and springs.

Kit with tools and valves - 6R80-VBR-WT

Refill kit ony (NO tools)   - 6R80-VBR-NT